Skinners Magnet Adhesive ME SME

$0.00

Product may vary slightly from image representation.
Skinners Magnet Adhesive

ME SME

The ULTIMATE adhesive for gluing in all magnets

As used by all the top motor builders

method 1:
#1 clean surface to be bonded (lightly sand back of magnets with 400 paper or wire brush with dremel.)
Remove any loose magnet dust with magnet putty then wash off with MEK or Acetone solvent. Clean inside of can then cross hatch with exacto blade and wash with MEK or Acetone.

#2 Apply a thin coating to both the magnets and can surfaces to be bonded. Allow 25 minutes for parts to air dry

#3 Place magnets in can, position with v blocks or a slug then place in pre heated oven @ 82°C (180 F) for 15 minutes. Remove from oven then let cool. Make final magnet adjustments if necessary.

#4 Pre-heat oven to 176°C (350 F) place setup in oven for 25 minutes remove, cool and hone to desired gap.

method 2:
Prep as above

bake for approx 47 mins at 177°C (350°F)

Manufacturers